24/7 AI Chatbot

RAID Reinstallation

RAID reinstallation instructions.

REQUIREMENTS:

  1. A USB with 8GB of storage space (32GB Max)

  2. A little bit of handiness, and a little knowledge about PCs

THIS WAY OF REINSTALLING IS HIGHLY RECOMMENDED!

🌟 Easiness: 7/10 Medium | 15 Minutes Average Time. 🕒

WHY IS THIS HIGHLY RECOMMENDED?

The reason this reinstallation is recommended, especially for people with a lot of HWID bans on their PC, is because this reinstallation method changes your disk drive serials too. This is an important factor and almost a 99% successful spoof at the end. Reminder: This guide is for AMD ONLY, unless u know what ur doing on Intel. 💢

HOW TO REINSTALL & SPOOF DISKS (BYPASS DISK BAN)

LogoDownload Windows 10

  • Download the Media Creation Tool above, click "Download Now"

  • Open the Media Creation Tool as an administrator

  • Select Create Installation media (USB Flash drive)

  • Use all the recommended options & continue & wait for it to finish.

[1] AMD RAID FILES: DOWNLOAD RAID FILES <- PUT FILES ON THE USB. MAKE SURE TO REMEMBER YOUR DISK SERIALS. MAKE A PHOTO OF THEM ON YOUR PHONE.

YOUR USB SHOULD LOOK SIMILAR LIKE THIS SCREENSHOT

NOTE: When reinstalling Windows, most modern systems will automatically detect and install basic Ethernet drivers, so ur connection will work fine after the installation. ✅ In some cases, you may need to manually download and install network drivers. Make sure to download your network drivers (LAN) from your corresponding motherboard model. So for example "Asus B550 Network drivers" on Google, and put them in the USB drive. You can skip this step since this is just a precaution, but there is a small risk of no connection after Windows reinstallation. 🌐

🔹 STEP 2: BOOT INTO BIOS

Once completed, and the USB looks like the screenshot above, restart the computer, and boot into bios. How to boot into BIOS: Video tutorial here (simple). ✅

🔹 STEP 3: ENABLE RAID MODE IN BIOS

Once in BIOS, follow the steps listed here down below to enable RAID.

Advanced > Integrated peripherals (or) Storage Configurations. SATA Mode > "RAID" / NVME Mode > "RAID" SAVE & EXIT BIOS, GET BACK INTO BIOS AGAIN AFTER.

🔹 STEP 4: RAID SETUP VIDEO

BIOS RAID Configuration (simple) <- video instructions for RAID setup. 💾

  • USE WINDOWS 10 PRO | MAKE AN OFFLINE ACCOUNT

  • Turn OFF All privacy questions/settings

Make sure to follow these steps while and after reinstallation: 1. Make an offline account or a new Microsoft account. Don't log in to the old ones. 2. Do not log in to OneDrive, Gefore Experience, & Medal using the same account. 3. Install: https://aka.ms/vs/17/release/vc_redist.x64.exe to prevent any errors.

WHEN YOU ARE ON WINDOWS:

🔹 STEP 5: CHECK OLD VS NEW DISK SERIALS

Now, use the "disk-serialchecker.exe" and see if the serials are changed, compare old vs new. If not changed, contact support, and we will find a solution. 🤝

PreviousNormal ReinstallationNextBIOS Configurations

Last updated